-
-
Prepare the LCD controller and LCD-support printed parts as shown in the picture
-
-
-
Adjust the LCD-support parts as shown in picture
-
LCD-support parts must face directly into the cutouts in LCD-cover
-
-
-
Press the LCD controller with LCD-support into the LCD-cover as shown in picture
-
Press it as deep as possible (SD card slot has to be in same position as in picture)
-
-
-
Plug in the cables as shown in picture
-
Cable with 2 stripes has to be plugged in connector labeled with EXT2
-
Cable with 1 stripe has to be plugged in connector labeled with EXT1
-
-
-
Use a ziptie to anchor the LCD assembly to the bottom threaded rod as shown in picture
-
Repeat the steps for the other side as shown on second picture
-
-
-
Congratulations! You've attached LCD to the Prusa i3 3D printer!
-
You can continue by assembling PSU and heatbed by clicking on following link
-
Cancel: I did not complete this guide.
18 other people completed this guide.