Skip to main content

Changes to Step #5

Edit by Jakub Dolezal

Edit approved by Jakub Dolezal

Before
After
Unchanged

Step Lines

+[title] Wrapping X-axis cable (optional)
+[* black] In order to match the wrapping style of the printer, an extra textile sleeve is included for the X-axis motor cable. You can remove the spiral wrap and replace it with the textile sleeve, or leave the wrap in place. ***It is up to you, this step is optional ;)***
+[* black] ***For the following step, please prepare:***
+[* violet] Textile sleeve 6 x 300 mm (1x)
+[* blue] Zip tie (1x)
+[* green] Wrap the sleeve around the X-axis motor cable. The sleeve is shorter, than the motor cable.
+[* orange] Secure the sleeve using a zip tie, you have to tighten the zip tie firmly and it is only a temporary fix until the Einsy case is assembled, but you can leave the zip tie in place afterwards.
+[* icon_note] Note the rest of this chapter was photographed with the spiral wrap, but the assembly procedures are the same for the textile sleeve.

Image 1

No previous image

Added

Image 2

No previous image

Added

Image 3

No previous image

Added