Skip to main content

Changes to Step #8

Edit by Jakub Dolezal

Edit approved by Jakub Dolezal

Before
After
Unchanged

Step Lines

+[title] Mounting the RAMBo-cover-base (part 1)
+[* orange] Push the spiral wrap in the slot and leave some slack of the cable along the board (don't stretch the cable).
+[* violet] See the slots on the printed part, which will be used for the M3x10 screws (those are already on the frame).
+[* blue] Slide the RAMBo-cover-base on the prepared M3x10 screws and align it with the edge of the Z-axis frame.
+[* yellow] Using 2.5mm Allen key tighten both screws.