Skip to main content

Changes to Step #19

Edit by Jakub Dolezal

Edit approved by Jakub Dolezal


Step Lines

[title] Connecting the extruder cable bundle (part 2)
[* light_blue] Insert both M3n nuts in the traps on the RAMBo-cover-base, see the picture. Make sure the nuts are all the way in.
[* green] Take the Rambo-extruder-cable-clip and press it against the extruder cable bundle.
[* orange] Using M3x10 screws fix the clip in place, tighten both screws equally.
[* icon_caution] ***Read*** the text and pictures in the next step ***carefully***, as you need to connect the v-cables to multiple ports!
+[* icon_note] This step was photographed with the spiral wrap, but the assembly procedure is the same for the textile sleeve.