Skip to main content

Changes to Step #22

Edit by Jakub Dolezal

Edit approved by Jakub Dolezal

Before
After
Unchanged

Step Lines

[title] Connecting the extruder cable bundle (part 3)
[* black] Connect the extruder from the heatbed to the RAMBo board:
-[* violet] P.I.N.D.A. probe
-[* yellow] Extruder motor
+[* violet] P.I.N.D.A. probe (v-cable, 4 wires)
+[* blue] Left hotend fan (v-cable, 3 wires)
+[* yellow] Extruder motor (yellow label with "E")
[* orange] Extruder heater
-[* green] Extruder thermistor (cable going from the extruder labeled with Yellow/Green heat shrink) [Orientation does not matter]
-[* red] Print fan (cable going from the extruder labeled with Red heat shrink)[make sure that the red wire is closer to the thermistor]
-[* blue] Extruder fan (cable going from the extruder labeled with Blue heat shrink)
-[* icon_caution] DOUBLE CHECK the connection! It is so important to ensure the correct connections.
+[* green] Extruder thermistor (yellow/green heat shrink, orientation does not matter)
+[* red] Front print fan (red heat shrink, ensure that the red wire is closer to the extruder thermistor)
+[* icon_caution] DOUBLE CHECK the connections! It is very important to ensure all cables are plugged correctly!

Image 1

Old Version

New Version

Image 2

No previous image

Added