Skip to main content

Changes to Step #22

Edit by TestingPrusaResearch

Edit approved by TestingPrusaResearch

Before
After
Unchanged

Step Lines

[title] Connecting the extruder cable bundle (part 3)
[* black] Connect the extruder from the heatbed to the RAMBo board:
[* violet] P.I.N.D.A. probe (v-cable, 4 wires)
[* blue] Left hotend fan (v-cable, 3 wires)
[* yellow] Extruder motor (yellow label with "E")
[* orange] Extruder heater
[* green] Extruder thermistor (yellow/green heat shrink, orientation does not matter)
[* red] Front print fan (red heat shrink, ensure that the red wire is closer to the extruder thermistor)
-[* icon_caution] DOUBLE CHECK the connections! It is very important to ensure all cables are plugged correctly!
+[* light_blue] Filament sensor cable (use the lower row of pins in the connector and ensure the red wire is on the right, facing the outside of the board)

Image 2

Old Version

New Version