Skip to main content

Changes to Step #22

Edit by Jakub Dolezal

Edit approved by Jakub Dolezal

Before
After
Unchanged

Step Lines

+[title] Connecting the extruder cable bundle (part 3)
+[* black] Connect the extruder from the heatbed to the RAMBo board:
+[* violet] P.I.N.D.A. probe
+[* yellow] Extruder motor
+[* orange] Extruder heater
+[* green] Extruder thermistor (cable going from the extruder labeled with Yellow/Green heat shrink) [Orientation does not matter]
+[* red] Print fan (cable going from the extruder labeled with Red heat shrink)[make sure that the red wire is closer to the thermistor]
+[* blue] Extruder fan (cable going from the extruder labeled with Blue heat shrink)
+[* icon_caution] DOUBLE CHECK the connection! It is so important to ensure the correct connections.

Image 1

No previous image

Added