Skip to main content

Changes to Step #22

Edit by Jakub Dolezal

Edit approved by Jakub Dolezal

Before
After
Unchanged

Step Lines

[title] Connecting the extruder cable bundle (part 3)
[* black] Connect the cables from the extruder to the RAMBo board:
[* violet] P.I.N.D.A. probe (v-cable, 4 wires)
[* blue] Left hotend fan (v-cable, 3 wires)
[* yellow] Extruder motor (yellow label with "E")
[* orange] Extruder heater
[* green] Extruder thermistor (yellow/green heat shrink, orientation does not matter)
-[* red] Front print fan (red heat shrink, ensure that the red wire is closer to the extruder thermistor)
+[* red] Front print fan (red heat shrink, ensure that the red wire is closer to the extruder thermistor connector)
[* light_blue] Filament sensor cable (use the lower row of pins in the connector and ensure the red wire is on the right, facing the outside of the board)