Skip to main content

Changes to Step #18

Edit by TestingPrusaResearch

Edit approved by TestingPrusaResearch

Before
After
Unchanged

Step Lines

[title] Connecting v-cables to the Extruder cables
[* black] Original Prusa i3 MK2.5 upgrade brings several improvements from the MK3, however, there are not enough pins on the on RAMBo 13a(10a) board's connectors. ***Using v-cables we will split one cable into two connectors.***
-[* green] Take v-cable for the PINDA V2 probe and connect it to the PINDA probe cable from the Extruder.
-[* light_blue] Take v-cable for the Left hotend fan and connect it to the Left hotend fan cable from the Extruder.
+[* yellow] Take v-cable for the PINDA V2 probe and connect it to the PINDA probe cable from the Extruder.
+[* violet] Take v-cable for the Left hotend fan and connect it to the Left hotend fan cable from the Extruder.
[* icon_note] Quick check: PINDA probe is using 4 wires, therefore, you need to connect v-cable with 3+1 wires.
[* orange] Press the cable bundle from the heatbed in the hole on RAMBo-cover-base. Make sure the textile sleeve is partly in.

Image 1

Old Version

New Version